Black LED Projector Headlights Pair for Toyota Camry LE / SE / Nightshade (2025-2026)

Fresh lamps for the new Camry. This black-housing LED projector pair is the OE-style replacement for a 2025-2026 LE, SE or Nightshade whose headlights are cracked, cloudy or damaged. Each lamp bolts to the factory points and plugs into the factory connectors, with the bulbs and 3-pin plugs already installed, so there is no splicing and no bulb transfer.

Fitment

Specs

• Sold as: driver and passenger pair
• Housing: black, clear lens, amber reflector
• Low and high beam: LED projector
• Bulbs, 3-pin plugs, sockets, resistors and circuit board included, already installed
• DOT and SAE compliant
• Plugs into the factory connectors (no splicing)

In the Box

• Driver-side LED projector headlight
• Passenger-side LED projector headlight
• 3-pin plugs, bulbs, sockets, resistors, circuit board and connector plate (already installed)

Interchange References

Replaces the original assemblies commonly crossed with 81150-AQ010, 81110-AQ010, TO2502343, TO2503343.

Installation: Toyota Camry LE / SE / Nightshade (2025-2026)

On the 2025-2026 Camry the headlight bolts are reached after the front bumper cover comes off. Give yourself a couple of hours and a helper to hold the cover. Turn the lights and ignition off before you start, and stay organized with the radar and sensor plugs on the bumper.

1. Tape the fender and bumper edges. Remove the fasteners across the top of the bumper and grille, the screws in each wheel well and the bolts underneath, then release each bumper corner.
2. With a helper, ease the cover forward, unplug any radar, camera or sensor connectors and set the cover on a soft surface.
3. Remove the three shorter bolts on top of the headlight and the longer bolt on the side, support the lamp and unplug its connector.
4. Plug the new lamp in, set it on the locating points, start every bolt by hand and tighten them evenly so the gaps to the hood and fender stay even.
5. Reconnect every bumper plug, refit the cover and all fasteners, test low beam, high beam and turn signal, then aim the beams.

Frequently Asked Questions

Which vehicles do these headlights fit?
2025-2026 Toyota Camry LE, SE and Nightshade sedans (2.5L I4) with this factory LED projector headlight. They do not fit the XLE or XSE, or 2018-2024 Camrys. Compare your current lamps with our photos before ordering.

Is this a pair or a single lamp?
This is a complete driver and passenger pair, not a single-side lamp.

Will these fit a Camry XLE or XSE?
No. The 2025-2026 XLE and XSE use a different headlight. This pair is only for the LE, SE and Nightshade.

Are bulbs included?
Yes. The LED bulbs, 3-pin plugs, sockets and circuit board come already installed.

Do I need to cut or splice any wiring?
No. Each lamp plugs into the factory connectors.

How are they installed on a 2025-2026 Toyota Camry LE / SE?
The front bumper cover has to come off. Then remove the three top bolts and the longer side bolt, unplug the lamp and install the new one. Reconnect any radar or sensor plugs on the bumper and aim the beams.