Black Sequential LED Tail Lights Pair for Toyota 4Runner (2003-2009)
$330.95
Passer aux informations sur le produit
Black Sequential LED Tail Lights Pair for Toyota 4Runner (2003-2009)
$330.95
DS-PT0366A-S
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Upgrade your 2003-2009 Toyota 4Runner with this black-housing LED tail light pair. A light-guide running lamp with start-up animation, bright LED brake section, dynamic sequential turn signal and LED reverse light replace the factory lamps and bolt into the original mounting points.
Fitment
| Year | Make / Model | Fits |
|---|---|---|
| 2003-2009 | Toyota / 4Runner | All 2003-2009 4Runner trims (4th generation) |
Features
- Light-guide LED running light with start-up animation
- LED brake light
- Dynamic sequential LED turn signal
- LED reverse light
- Black ABS housing, polycarbonate lens
- IP67 sealed, DOT / SAE compliant (per supplier)
Signs you need new tail lights
- Cracked, faded or hazy lens
- Water or condensation inside
- Dead LED sections or broken sockets
What's included
- 1 x driver side (left) tail light
- 1 x passenger side (right) tail light
- Connection harness
- All LEDs built in. No extra bulbs needed
Installation: 2003-2009 Toyota 4Runner (4th gen (N210))
Tools: 10 mm socket, Phillips screwdriver, plastic trim tool. About 15-20 minutes per side.
- Open the rear liftgate. Each tail light is held by screws on its inner edge, visible in the liftgate opening.
- Remove the screws, then pull the lamp straight back to release it from the body clips.
- Twist out or unplug the factory sockets / connector and set the old lamp aside.
- Connect the new lamp using the supplied harness, routing the wire so it is not pinched.
- Seat the lamp in its clips and refit the screws.
- Test running, brake, turn and reverse on both sides.
- If the turn signal flashes fast, add a load resistor or LED flasher.
FAQ
What does this fit?
All 2003-2009 4Runner trims (4th generation).
Are bulbs included?
Yes. The lamps are fully LED with every light source built in, so no extra bulbs are needed.
Does it have a sequential turn signal?
Yes. The turn section lights in a dynamic sequential sweep, and the running light plays a start-up animation.
Is this sold as a pair?
Yes: driver side (left) and passenger side (right).
How long does installation take?
About 15-20 minutes per side with basic hand tools.