Black Sequential LED Tail Lights Pair for Toyota Highlander LE / SE (2014-2019)
$405.95
Passer aux informations sur le produit
Black Sequential LED Tail Lights Pair for Toyota Highlander LE / SE (2014-2019)
$405.95
DS-PT0154A-BRB
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Upgrade your 2014-2019 Toyota Highlander with this black-housing LED tail light pair. A light-guide running lamp with start-up animation, bright LED brake section, dynamic sequential turn signal and LED reverse light replace the factory lamps and bolt into the original mounting points.
Fitment
| Year | Make / Model | Fits |
|---|---|---|
| 2014-2019 | Toyota / Highlander | 2014-2019 Highlander (3rd generation, listed for LE / SE trims) |
Features
- Light-guide LED running light with start-up animation
- LED brake light
- Dynamic sequential LED turn signal
- LED reverse light
- Black ABS housing, polycarbonate lens
- IP67 sealed, DOT / SAE compliant (per supplier)
Signs you need new tail lights
- Cracked, faded or hazy lens
- Water or condensation inside
- Dead LED sections or broken sockets
What's included
- 1 x driver side (left) tail light set (outer + inner)
- 1 x passenger side (right) tail light set (outer + inner)
- Connection harness
- All LEDs built in. No extra bulbs needed
Installation: 2014-2019 Toyota Highlander (3rd gen (XU50))
Tools: 10 mm socket, Phillips screwdriver, plastic trim tool. About 30-40 minutes per side.
- Open the liftgate. Remove the liftgate inner trim panel (plastic trim tool) to reach the inner lamp nuts, and the side access cover in the cargo area for the outer lamp.
- Unplug the factory connectors.
- Remove the retaining nuts and pull each lamp section straight back off its studs and clips.
- Fit the new outer and inner sections, refit the nuts and connect the supplied harness.
- Refit the trim panels.
- Test running, brake, turn and reverse on both sides.
- If the turn signal flashes fast, add a load resistor or LED flasher.
FAQ
What does this fit?
2014-2019 Highlander (3rd generation, listed for LE / SE trims).
Are bulbs included?
Yes. The lamps are fully LED with every light source built in, so no extra bulbs are needed.
Does it have a sequential turn signal?
Yes. The turn section lights in a dynamic sequential sweep, and the running light plays a start-up animation.
Is this sold as a pair?
Yes: driver side (left) and passenger side (right) outer and inner sections.
How long does installation take?
About 30-40 minutes per side with basic hand tools.