Chrome Halogen Projector Headlights Pair w/ Bulbs for Cadillac ATS w/o LED DRL (2013-2018)

Replace yellowed or damaged headlights on your 2013-2018 Cadillac ATS with this brand-new pair of halogen projector headlight assemblies for cars WITHOUT the LED DRL, bulbs included.

Fitment

Will NOT fit: ATS with factory HID or LED DRL headlights; ATS-V unless your lamp matches; CTS.

Common Reasons to Replace

• Yellowed, hazy, or oxidized lenses reducing light output
• Cracked lens or broken mounting tabs
• Moisture or condensation inside the housing
• Collision damage

Specs

• Housing: Black/chrome
• Lens: Clear
• Type: Halogen projector
• LED DRL: none (non-DRL type)
• Bulbs: included (size not stated in listing)
• DOT compliant
• Quantity: Pair (Left + Right)
• Condition: New

Interchange Part Numbers

OEM: 23236365, 22922433, 22936967, 22981477, 23103879, 23119391, 23180169, 22922432, 22936968, 22981478, 23103880, 23119392, 23180170. Partslink: GM2502384 GM2503384.

What's Included

• 1 x Driver side headlight assembly
• 1 x Passenger side headlight assembly
• Bulbs included

Installation

1. Disconnect the negative battery cable and remove the radiator/engine-bay shroud.
2. Remove the wheel-well screws and clips and the lower fascia fasteners, unplug any parking-assist sensors and lower the fascia.
3. Remove the four headlamp screws, unplug the connector and pull the lamp out.
4. Install the new lamp, tighten the screws to 2.5 Nm (22 lb-in), refit the fascia and aim the headlights.

Steps compiled from the GM 2013-2018 ATS service manual (headlamp replacement) and Smart Enough to DIY ATS guide. Professional installation and headlight aiming are recommended.

FAQs

What bulb sizes do these headlights use?
Bulbs are included; the listing does not state the headlight bulb size, so match your factory bulb size if you ever replace them.

How do I tell if my ATS has the LED DRL?
Per the listing match photo, these fit headlights without the vertical LED DRL strip. If your headlight has the LED DRL, these do not match.

Do I need to remove the front bumper to replace these headlights?
Yes. On the ATS the front fascia comes off (engine-bay shroud, wheel-well screws and clips), then four screws hold each headlight. Tighten them to 2.5 Nm (22 lb-in).

Can I install HID or LED kits?
Yes. This is a halogen projector housing, so a plug-in LED or HID kit in your factory bulb size can be used. Aim afterward.