Flush mount red LED tail lights pair on white background for Jeep Wrangler JL 2018-2024

Flush Mount Red LED Tail Lights Pair for Jeep Wrangler JL (2018-2024)

$349.95
Passer aux informations sur le produit
Flush mount red LED tail lights pair on white background for Jeep Wrangler JL 2018-2024

Flush Mount Red LED Tail Lights Pair for Jeep Wrangler JL (2018-2024)

$349.95
DS-JL-TAIL-FLUSH-RED-LED-PAIR-2018-2024

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Give your 2018-2024 Wrangler JL a cleaner rear profile—flush-mount red LED tails replace the protruding factory housings with a body-hugging LED signature that reads modern by day and unmistakable when you brake. GENSSI left/right direct-fit assemblies are built for JL/JLU openings, not cheap universal covers.

Important Fitment Note: Sold as a flush-mount pair (left & right) for 2018-2024 Jeep Wrangler JL / JLU. These replace the factory outer tail housings—not a tint overlay for the stock lamps.

Fitment

YEAR MAKE / MODEL SUBMODEL FITS
2018-2024 Jeep Wrangler JL 2-door / 4-door (JLU) Yes

Specs

  • Type: Flush-mount LED tail light assemblies (pair)—not a universal cover
  • Lighting: LED — instant-on so trailing drivers see your brake hit sooner
  • Lens color: Red
  • Housing color: Black
  • Placement: Rear, outer, left & right
  • Sold as: Pair (2 pieces)
  • Fitment type: Direct replacement — plug into the factory harness, no splicing
  • Material: ABS sealed assembly

What's included

  • 1 x left flush-mount red LED tail light assembly
  • 1 x right flush-mount red LED tail light assembly

Installation — 2018-2024 Jeep Wrangler JL

Tools: Plastic trim tool, T40 Torx or 10 mm socket, Phillips screwdriver. Work one side at a time.

  1. Open the tailgate. On the interior behind each tail lamp, pry off the rubber/plastic access cap with a trim tool.
  2. Remove the single T40 Torx (or 10 mm) retention bolt from the access hole. Keep the spring-loaded bolt together so parts are not lost.
  3. Pull the factory outer tail lamp straight back to unseat it from the body.
  4. On the harness plug, slide the red lock tab back, press the gray release tab, and disconnect the connector.
  5. If your new flush-mount assembly requires the factory mounting bracket, transfer it: remove the three Phillips screws, release the retaining clip, and install the bracket on the new housing.
  6. Reconnect the harness until it clicks, seat the new lamp on the locating pins, and hand-start the retention bolt. Snug only—do not overtighten or you can strip the plastic.
  7. Snap the access cap back on, repeat on the other side, then test tail, brake, turn, and reverse.

Buyer FAQ

Are these stick-on covers for my JL? No. They are full flush-mount LED housings that replace the factory outer tail lamps.

Do I need to splice wiring? No. They are designed to plug into the factory JL harness.

What years does this pair fit? 2018-2024 Jeep Wrangler JL and JLU (2-door and 4-door).

Vous aimerez peut-être aussi