HID Projector Headlights Pair w/ LED DRL for Audi A3 (2015-2016)

Replace yellowed or cracked HID headlights on your 2015-2016 Audi A3 (8V) with this brand-new pair of HID projector headlights with LED DRL. Reuse your D3S bulbs and ballasts.

Fitment

Will NOT fit: Halogen A3; full-LED A3; 2017+ facelift A3.

Common Reasons to Replace

• Yellowed, hazy, or oxidized lenses reducing light output
• Cracked lens or broken mounting tabs
• Moisture or condensation inside the housing
• Collision damage

Specs

• Low beam: D3S HID (not included)
• Turn signal: PWY24W
• DRL/side marker: LED
• DOT compliant
• Quantity: Pair (Left + Right)
• Condition: New

Interchange Part Numbers

OEM: 8V0941043B. Partslink: AU2502191, AU2503191.

What's Included

• 1 x Driver side headlight assembly
• 1 x Passenger side headlight assembly
• PWY24W, LED DRL and side marker included
• Half assembly: HID bulbs, ballasts, and high-voltage wires are NOT included; reuse yours

Installation

1. Open the hood, remove the upper bumper/grille bolts and the lower bumper bolts.
2. Peel back the wheel-arch liners, remove the 10 mm fender-to-bumper nut, release the clips and unplug wiring/washer hoses; remove the bumper.
3. Remove the three T30 headlamp bolts (two upper, one rear-lower), unplug and remove the lamp.
4. Move your D3S bulb and ballast over, install in reverse and aim.

Steps compiled from Audizine "DIY: Bumper Removal, Headlight Removal" thread and Remont-bampera A3 8V guide. Professional installation and headlight aiming are recommended.

FAQs

What bulbs do these headlights use?
Per the listing: D3S HID (not included), PWY24W turn signal, LED DRL and side marker included.

Will these fit a 2017 A3?
No. The 2017+ facelift uses a different headlight.

Do I need to remove the front bumper to replace these headlights?
Yes. The front bumper comes off, then each headlamp is held by three T30 bolts.

Can I install HID or LED kits?
Not applicable. These are factory-style HID/Xenon housings; reuse your factory HID bulbs and ballasts.