JDM Style Smoke LED Tail Lights for Honda CR-V (2002-2006)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Stock 2nd-gen CR-V reds look dated next to a molded-smoke LED rear—this pair puts a cleaner JDM night signature on the RD chassis. GENSSI's 2002-2006 Honda CR-V kit is a vehicle-specific smoke LED tail pair that bolts in and plugs into the factory harness.
Important Fitment Note: Fits 2002-2006 Honda CR-V. Smoke lens with built-in LED parking/brake—not a tint film or cover set.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 2002-2006 | Honda / CR-V | Yes |
Specs
- Style: Chrome housing, molded smoke / tinted lens with built-in LED parking / brake
- Bulbs: Built-in LED parking / brake; W21W (7440) reverse and 921 signal — reuse or replace separately
- Sold as: JDM-style smoke LED tail light pair
- Fit: Direct-fit smoke LED tails for 2002-2006 Honda CR-V
Interchange
33551-S9A-A00, 33501-S9A-A00, 33551-SCA-A00, 33501-SCA-A00, 33551-S9A-A11, 33501-S9A-A11, 33551-SCA-A11, 33501-SCA-A11, HO2818126, HO2818127, HO2818128, HO2818139, HO2819126, HO2819127, HO2819128, HO2819139
What's included
- 1x Driver smoke LED tail light
- 1x Passenger smoke LED tail light
Installation — Honda CR-V (2002-2006)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the hatch. Pull back the rear side trim to reach the tail light mounting nuts and harness connectors on each quarter panel.
- Disconnect each harness. Remove the mounting nuts and slide the factory left and right assemblies straight back out of the body openings.
- Seat each new smoke LED assembly, reconnect the plugs, and snug the fasteners while checking quarter-panel gaps. Transfer or install reverse (7440) and signal (921) bulbs as needed.
- Refit the hatch trim, reconnect the battery, and test parking / brake LED, turn, and reverse on both sides.
Buyer FAQ
Is the smoke just a tint film? No. The smoke is molded into the lens with a built-in LED parking/brake design—not stick-on tint.
Which functions are LED? Parking and brake use built-in LEDs. Reverse uses W21W (7440) and signal uses 921 sockets.
Do I splice wiring? No. After hatch access, the assemblies bolt in and plug into the factory harness.