LED Projector Headlights Pair w/ LED DRL, 8-Pin for VW Jetta (2019-2024)

Replace damaged LED projector headlights on your 2019-2024 Volkswagen Jetta SEL or GLI with this brand-new black-edged LED projector pair.

Fitment

Will NOT fit: Jetta S/SE with non-projector LED; 2018 and older Jetta.

Common Reasons to Replace

• Yellowed, hazy, or oxidized lenses reducing light output
• Cracked lens or broken mounting tabs
• Moisture or condensation inside the housing
• Collision damage

Specs

• Low/high beam, DRL, side marker: LED
• Turn signal: PWY24W
• Connector: 8-pin
• DOT compliant
• Quantity: Pair (Left + Right)
• Condition: New

Interchange Part Numbers

OEM: 17A941036F, 17A-941-036-B, 17A-941-036-C, 17A-941-035-B，17A-941-035-C. Partslink: .

What's Included

• 1 x Driver side headlight assembly
• 1 x Passenger side headlight assembly
• LED module included

Installation

1. Disconnect the battery. Turn the wheels, remove the three T25 wheel-liner screws and the upward T25 bumper-to-fender screw on each side.
2. Remove the four T25 screws on top of the grille, then the T25 screws under the bumper corners and center.
3. Pull evenly at the fender seam to release the side clips, unclip the center latches, and unplug fog lights and ACC/front-assist sensors before lifting the bumper off.
4. Remove the headlamp T30 bolts, unplug the lamp, install the new one flush with the fender and with its bottom slots on the bumper tabs; refit and aim.

Steps compiled from VWVortex "MK7 Jetta front bumper removal how-to" and CJM Industries MK7 Jetta bumper removal guide. Professional installation and headlight aiming are recommended.

FAQs

What bulbs does it use?
Per the listing image: LED low/high beam, DRL and side marker; PWY24W turn signal.

Will these fit a Jetta S?
No. Projector-equipped trims only.

Do I need to remove the front bumper to replace these headlights?
Yes. On the 2019-2024 MK7 Jetta the front bumper cover has to come off to reach the headlamp mounting bolts.

Can I install HID or LED kits?
Not applicable. The low and high beams are built-in factory LED; there is no replaceable headlight bulb for an LED or HID kit.