Red and Clear Halogen Tail Lights Pair for Chrysler PT Cruiser (2006-2010)
$99.95
Passer aux informations sur le produit
Red and Clear Halogen Tail Lights Pair for Chrysler PT Cruiser (2006-2010)
$99.95
DS-5116222AB
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Chrysler PT Cruiser (2006-2010) only. They will not fit 2001-2005 PT Cruiser, which uses a different red and amber lens. Compare your current housings with our photos before ordering.
Refresh a 2006-2010 PT Cruiser with this red and clear halogen pair. Each teardrop housing has a clear upper section and a red lower tail and brake section. 3157 bulbs are included. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2006-2010 | Chrysler PT Cruiser | Facelift red and clear halogen housing. Not 2001-2005 |
Specs
- Sold as: a driver and passenger pair
- Style: red and clear teardrop lens
- Lighting: halogen tail, brake, and turn; 3157 bulbs included
- DOT / SAE certified
- 12 V
- New aftermarket assemblies
In the Box
- Driver and passenger red and clear halogen tail lights
- 3157 bulbs
Interchange References
Replaces original-style 2006-2010 PT Cruiser tail lights commonly crossed with 5116222AB and 5116223AB.
Installation: Chrysler PT Cruiser (2006-2010)
On the facelift PT Cruiser these tail lights mount at the rear corners, with the fasteners reached with the hatch open. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
- Open the hatch. Locate the tail light fasteners on the back of the housing; pull back any interior trim that covers them.
- Unplug the factory connector.
- Remove the fasteners and pull the housing straight out of the opening. Do not pry on the lens.
- Install the included 3157 bulbs, seating each bulb fully in its socket.
- Set the new housing into the opening, start the fasteners by hand, then tighten them evenly. Plug the factory connector back in until it clicks.
- Repeat on the other side. Reinstall any trim, reconnect the battery, and check tail, brake, and turn functions before you drive.