Red and Clear Halogen Tail Lights Pair for Toyota Tundra (2007-2013)
$105.95
Passer aux informations sur le produit
Red and Clear Halogen Tail Lights Pair for Toyota Tundra (2007-2013)
$105.95
DS-815500C090
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Toyota Tundra (2007-2013) only, including Regular Cab, Double Cab, and CrewMax. They will not fit 2000-2006 Tundra or 2014-up Tundra. Compare your current housings with our photos before ordering.
Replace worn 2007-2013 Tundra tails with this red and clear halogen pair. You get driver and passenger assemblies in a chrome housing, with the red tail and brake section stacked over a clear reverse lens. Halogen bulbs are included. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2007-2013 | Toyota Tundra | Regular Cab, Double Cab, and CrewMax. Red and clear halogen housing |
Specs
- Sold as: a driver and passenger pair
- Style: chrome housing, red and clear lens
- Lighting: halogen tail, brake, turn, and reverse; bulbs included
- DOT certified
- 12 V
- New aftermarket assemblies
- OEM cross-reference: 81550-0C090, 81550-0C090, 81560-0C090, 81560-0C070, TO2800183, TO2801183, TO2800165, TO2801165
What’s in the box
- Driver tail light assembly
- Passenger tail light assembly
- Halogen bulbs
Installation
- Open the tailgate and support it so you can reach the bedside bolts behind each lamp.
- Remove the two bolts that hold the assembly to the bedside.
- Pull the housing straight back off the bed, then unplug the factory connector and release the bulb sockets if they stay with the harness.
- Transfer any reusable sockets or bulbs, seat the new housing on the factory mounting points, reconnect, and tighten the bolts.
- Repeat on the other side, then check tail, brake, turn, and reverse functions before closing the tailgate.
A do-it-yourself installer can usually finish both sides in about 30-45 minutes with basic hand tools. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.