GENSSI hero — red and clear tail lights pair for Honda CR-V (1997-2001) on white

Red Clear Tail Lights Pair for Honda CR-V (1997-2001)

$244.95
Passer aux informations sur le produit
GENSSI hero — red and clear tail lights pair for Honda CR-V (1997-2001) on white

Red Clear Tail Lights Pair for Honda CR-V (1997-2001)

$244.95
DS-CRV-TAIL-RED-CLEAR-PAIR-1997-2001

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

An amber and red factory lens leaves a first-generation CR-V looking dated on the rear pillar, and this red and clear pair opens the turn and reverse sections while the brake stays red. GENSSI's set is a left and right assembly for the 1997-2001 CR-V, and the factory sockets twist in with no splicing.

Important Fitment Note: 1997-2001 CR-V only. A 2002-2006 CR-V uses a different housing.

Fitment

YEAR MAKE / MODEL FITS
1997-2001 Honda / CR-V Yes
2002-2006 Honda / CR-V No

Specs

  • Style: Black housing with a red brake lens, a clear turn lens, and a clear reverse lens
  • Bulbs: Incandescent. Bulbs and sockets are not included. Each side uses a 7443 for brake and park, a 7440 for the turn signal, and a 1156 for reverse
  • Sold as: Pair — left and right red and clear tail lights. Bulbs and sockets are not included
  • Fit: 1997-2001 Honda CR-V, every trim. Factory sockets, no splicing

Interchange

33551-S10-A01, 33501-S10-A01

What's included

  • 1x Driver (left) red and clear tail light
  • 1x Passenger (right) red and clear tail light

Installation — Honda CR-V (1997-2001)

  1. Confirm a 1997-2001 CR-V. A 2002-2006 CR-V uses a different lamp.
  2. Open the tailgate. The fasteners are three Phillips screws on the rear pillar. Use a Phillips screwdriver.
  3. Remove the three screws. Pull the lamp out from the pillar. Unplug the 6-pin connector. Do not hang the lamp from the wires.
  4. Twist out the three sockets: brake and park, turn, and reverse. The sockets and bulbs are not in the box.
  5. Lock those sockets into the new housing. The 7443 is brake and park, the 7440 is the turn signal, and the 1156 is reverse.
  6. Plug the 6-pin connector in. Set the lamp on the pillar and install the three screws. Snug them. Do not overtighten the plastic.
  7. Check park, brake, both turn signals, and reverse, then repeat on the other side. Run water over the gasket if you want to confirm it seals.

Buyer FAQ

Does a 2002 CR-V fit? No. This pair is the 1997-2001 lamp. A 2002-2006 CR-V uses a different housing.

Are the bulbs included? No. Move the factory sockets, the 7443, the 7440, and the 1156.

Which part numbers does this replace? Left replaces 33551-S10-A01. Right replaces 33501-S10-A01.

Vous aimerez peut-être aussi