Red Halogen Tail Lights Pair for Dodge Ram 1500 (2002-2006) / Ram 2500 3500 (2003-2006)
$99.95
Passer aux informations sur le produit
Red Halogen Tail Lights Pair for Dodge Ram 1500 (2002-2006) / Ram 2500 3500 (2003-2006)
$99.95
DS-55077348AF
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Dodge Ram 1500 (2002-2006) and Dodge Ram 2500 / 3500 (2003-2006) new-body-style bedsides that use this red and clear halogen housing. They will not fit 1994-2001 Ram, 2007-2009 mid-cycle tails, or 2009-2018 Ram. Compare your current housings with our photos before ordering.
Replace faded 2002-2006 Ram tails with this red halogen pair. Each housing has a red tail and brake section over a clear reverse section. Bulbs and a factory-style harness are included. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2002-2006 | Dodge Ram 1500 | New-body-style halogen housing. Not 1994-2001 or 2007-up |
| 2003-2006 | Dodge Ram 2500 | New-body-style halogen housing. Not 2007-up |
| 2003-2006 | Dodge Ram 3500 | New-body-style halogen housing. Not 2007-up |
Specs
- Sold as: a driver and passenger pair
- Style: red lens with a clear reverse section
- Lighting: halogen tail, brake, turn, and reverse; bulbs included
- DOT certified
- 12 V
- New aftermarket assemblies
In the Box
- Driver and passenger red halogen tail lights
- Bulbs
- Factory-style harnesses
Interchange References
Replaces original-style 2002-2006 Ram tail lights commonly crossed with 55077348AF and 55077347AF.
Installation: Dodge Ram 1500 (2002-2006) / Ram 2500 3500 (2003-2006)
On these Rams the tail light is held by nuts reached from inside the bedside with the tailgate open. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
- Open the tailgate. From inside the bed, locate the nuts on the back of the tail light.
- Unplug the factory connector.
- Remove the nuts and pull the housing straight back out of the bedside. Do not pry on the lens.
- Install the included bulbs, seating each bulb fully in its socket.
- Set the new housing into the opening, start the nuts by hand, then tighten them evenly. Plug the factory-style connector back in until it clicks.
- Repeat on the other side. Reconnect the battery and check tail, brake, turn, and reverse functions before you drive.