Red Sequential LED Tail Lights Pair for Chevy / GMC C/K / K5 Blazer / Jimmy / Suburban (1973-1987)
$151.95
Passer aux informations sur le produit
Red Sequential LED Tail Lights Pair for Chevy / GMC C/K / K5 Blazer / Jimmy / Suburban (1973-1987)
$151.95
DS-GM2806901-LED
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit 1973-1987 Chevrolet and GMC fleetside C/K trucks, K5 Blazer, Jimmy, and Suburban only. They will not fit stepside beds, and they will not fit 1988-up GMT400 trucks, which use a different housing. Compare your current lamps with our photos before ordering.
Replace the square-body fleetside tails with this red sequential LED pair. You get driver and passenger assemblies with LED tail, brake, turn, and reverse lighting and a sequential turn signature. The housings use the factory fleetside mounting points and factory-style connectors. This is a different design from later GMT400 LED tails.
Installation for 1973-1987 Chevy and GMC fleetside C/K, K5 Blazer, Jimmy, and Suburban
- On trucks, lower or remove the tailgate so you can reach the screws that hold the housing to the bed opening. On Blazer, Jimmy, and Suburban, open the rear doors or tailgate and reach the housing fasteners from inside.
- Remove the screws or nuts that hold the assembly in the opening.
- Pull the housing out and unplug the factory connector.
- Plug the new housing into the factory-style connector, seat it in the opening, and tighten the fasteners.
- Repeat on the other side, then check tail, brake, sequential turn, and reverse functions.
A do-it-yourself installer can usually finish both sides in about 30-45 minutes with basic hand tools. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.