Flush Mount Smoke LED Tail Lights Pair for Jeep Wrangler JL (2018-2024)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Stock JL tails stick out like an afterthought—these flush-mount smoke LED housings tuck the rear lighting into the body so your 2018-2024 Wrangler looks cleaner parked and sharper when the red LED signature hits at night. GENSSI direct-fit left/right assemblies replace the factory outer lamps with sealed LED units built for JL/JLU openings—not bolt-on covers.
Important Fitment Note: Sold as a flush-mount pair (left & right) for 2018-2024 Jeep Wrangler JL / JLU. These replace the factory outer tail housings—not a tint overlay for the stock lamps.
Fitment
| YEAR | MAKE / MODEL | SUBMODEL | FITS |
|---|---|---|---|
| 2018-2024 | Jeep Wrangler JL | 2-door / 4-door (JLU) | Yes |
Specs
- Type: Flush-mount LED tail light assemblies (pair)—not a universal cover
- Lighting: LED — instant-on so trailing drivers see your brake hit sooner
- Lens color: Smoke / Tinted — aggressive blackout look when parked
- Housing color: Black
- Placement: Rear, outer, left & right
- Sold as: Pair (2 pieces)
- Fitment type: Direct replacement — plug into the factory harness, no splicing
- Material: ABS sealed assembly
What's included
- 1 x left flush-mount smoke LED tail light assembly
- 1 x right flush-mount smoke LED tail light assembly
Installation — 2018-2024 Jeep Wrangler JL
Tools: Plastic trim tool, T40 Torx or 10 mm socket, Phillips screwdriver. Work one side at a time.
- Open the tailgate. On the interior behind each tail lamp, pry off the rubber/plastic access cap with a trim tool.
- Remove the single T40 Torx (or 10 mm) retention bolt from the access hole. Keep the spring-loaded bolt together so parts are not lost.
- Pull the factory outer tail lamp straight back to unseat it from the body.
- On the harness plug, slide the red lock tab back, press the gray release tab, and disconnect the connector.
- If your new flush-mount assembly requires the factory mounting bracket, transfer it: remove the three Phillips screws, release the retaining clip, and install the bracket on the new housing.
- Reconnect the harness until it clicks, seat the new lamp on the locating pins, and hand-start the retention bolt. Snug only—do not overtighten or you can strip the plastic.
- Snap the access cap back on, repeat on the other side, then test tail, brake, turn, and reverse.
Buyer FAQ
Are these stick-on covers for my JL? No. They are full flush-mount LED housings that replace the factory outer tail lamps.
Do I need to splice wiring? No. They are designed to plug into the factory JL harness.
What years does this pair fit? 2018-2024 Jeep Wrangler JL and JLU (2-door and 4-door).