LED Fog Lights Pair for Kenworth T680 (2013-2021)

Replace the factory bumper fog lamps on your 2013-2021 Kenworth T680 with this LED pair. Each assembly uses a round LED lamp on a square mounting plate with a pigtail connector. Sold as a driver and passenger pair.

Fitment

Specs

• Condition: New
• Sold as: Driver and passenger pair
• Lighting: LED
• Housing: Black square plate, clear lens
• Operating voltage: 12V
• Warranty: 1 year

In the Box

• Driver-side fog light assembly
• Passenger-side fog light assembly

Interchange References

H4070-83235L1, H4070-83235R1

Installation: Kenworth T680 (2013-2021)

These fog lamps mount in the front bumper opening that matches this housing. You usually reach the fasteners from the front or the underside of the bumper. Professional installation and aiming are recommended.

1. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
2. Unplug the harness at the back of the old fog lamp. Remove the mounting screws or clips that hold the lamp in the bumper.
3. Set the new lamp in the same opening, start the fasteners by hand, and snug them evenly. Do not overtighten the housing.
4. Reconnect the factory harness until it clicks. Repeat on the other side if you are installing a pair.
5. Reconnect the battery and test every lighting function. Aim the lamps on level ground before driving at night.

Frequently Asked Questions

Which trucks do these fog lights fit?
Kenworth T680 trucks from 2013 through 2021 with this square-plate LED bumper housing. Compare your current lamps with our photos before ordering.

Will they fit a 2022 or newer T680 Next Gen?
No. That generation uses a different lamp and is not covered.

Are these a complete pair?
Yes. You get the driver-side and passenger-side fog light assemblies.