Smoked Sequential LED Tail Lights Pair for Mini Cooper R56 / R57 / R58 / R59 (2007-2013)

Upgrade your 2007-2013 Mini Cooper R56 / R57 / R58 / R59 with this black-housing, smoked-lens LED tail light pair. A light-guide running lamp with start-up animation, bright LED brake section, dynamic sequential turn signal and LED reverse light replace the factory lamps and bolt into the original mounting points.

Fitment

2nd generation Mini Cooper and Cooper S: 2007-2013 Hardtop (R56), 2009-2013 Convertible (R57), 2012-2013 Coupe (R58) and Roadster (R59). Not Clubman or Countryman.

Features

• Light-guide LED running light with start-up animation
• LED brake light
• Dynamic sequential LED turn signal
• LED reverse light
• Black ABS housing, {v['c'].lower()} polycarbonate lens
• IP67 sealed, DOT / SAE compliant (per supplier)

Signs you need new tail lights

• Cracked, faded or hazy lens
• Water or condensation inside
• Dead LED sections or broken sockets

What's included

• 1 x driver side (left) tail light
• 1 x passenger side (right) tail light
• Connection harness
• All LEDs built in. No extra bulbs needed

Installation: 2007-2013 Mini Cooper R56 / R57 / R58 / R59 (R56)

Tools: 10 mm socket, Phillips screwdriver, plastic trim tool. About 15-20 minutes per side.

1. Open the liftgate and remove the side trim access cover on the cargo-area side panel behind each tail light.
2. Unplug the factory connector and remove the retaining nuts from the lamp studs.
3. Pull the lamp straight back to release its locating pins from the body.
4. Fit the new lamp on the studs, refit the fasteners and connect it with the supplied harness.
5. Refit the access cover.
6. Test running, brake, sequential turn and reverse on both sides.
7. If the turn signal flashes fast, add a load resistor or LED flasher.

FAQ

What does this fit?

2nd generation Mini Cooper and Cooper S: 2007-2013 Hardtop (R56), 2009-2013 Convertible (R57), 2012-2013 Coupe (R58) and Roadster (R59). Not Clubman or Countryman.

Are bulbs included?

Yes. The lamps are fully LED with every light source built in, so no extra bulbs are needed.

Does it have a sequential turn signal?

Yes. The turn section lights in a dynamic sequential sweep, and the running light plays a start-up animation.

Is this sold as a pair?

Yes: driver side (left) and passenger side (right).

How long does installation take?

About 15-20 minutes per side with basic hand tools.