Black Full LED Headlights Pair with LED DRL for Nissan Pathfinder S / SV / SL / Platinum (2022-2025)

Replace faded or cracked factory LED lamps on your 2022-2025 Pathfinder S, SV, SL or Platinum with this OE-style pair. Each black housing has the full LED low and high beam and the signature LED daytime running light, and it bolts to the factory points and plugs into the factory connectors, with no splicing.

Fitment

Specs

• Sold as: driver and passenger pair
• Housing: black, clear lens, amber side marker
• Low and high beam: full LED; daytime running light: LED, built in
• 12V
• 2-pin and 6-pin plugs, bulbs, sockets, ballast, resistors, LED control module, circuit board and connector plate included, already installed
• DOT and SAE compliant
• Plugs into the factory connectors (no splicing)

In the Box

• Driver-side full LED headlight with LED DRL
• Passenger-side full LED headlight with LED DRL
• 2-pin and 6-pin plugs, bulbs, sockets, ballast, resistors, LED control module, circuit board and connector plate (already installed)

Interchange References

Replaces the original assemblies commonly crossed with 26060-6TA7B, 26010-6TA7B, 26060-6TA6A, 26010-6TA6A, NI2502288, NI2503288.

Installation: Nissan Pathfinder S / SV / SL / Platinum (2022-2025)

On the 2022-2025 Pathfinder the front bumper cover comes off so you can reach the headlight bolts. The hood-ledge finisher at the fender, the grille and the corner clips come off with it. Turn the lights and ignition off before you start. Unplug the fog lights, front camera and sensors in the bumper as equipped.

1. Open the hood. Remove the clips and fasteners for the hood-ledge finisher and the top of the grille and bumper cover.
2. Remove the inner-fender and lower bumper fasteners at each corner and unplug the fog lights, front camera and sensors as equipped, then pull the bumper cover forward and set it aside.
3. Remove the headlight mounting bolts, slide the lamp forward and unplug the 2-pin and 6-pin connectors.
4. Plug the new lamp in, seat the locating points, and start all bolts by hand before tightening them evenly.
5. Refit the bumper cover, grille, hood-ledge finisher and any fog, camera or sensor connectors. Test low beam, high beam, LED DRL and turn signal, then aim the beams.

Frequently Asked Questions

Which vehicles do these headlights fit?
2022-2025 Nissan Pathfinder S, SV, SL and Platinum with factory full LED headlights with LED DRL. They do not fit the Pathfinder Rock Creek or the 2026 and newer Pathfinder. Compare your current lamps with our photos before ordering.

Is this a pair or a single lamp?
This is a complete driver and passenger pair, not a single-side lamp.

Will these fit a Pathfinder Rock Creek?
No. Rock Creek Pathfinders use a different lamp and are excluded.

Will these fit a 2026 Pathfinder?
No. 2026 and newer Pathfinders are a facelift and use a different lamp.

Are bulbs included?
Yes. The LED bulbs, 2-pin and 6-pin plugs, control module and ballast come already installed.

Do I need to cut or splice any wiring?
No. Each lamp plugs into the factory connectors.

How are they installed on a 2022-2025 Nissan Pathfinder S / SV / SL / Platinum?
The front bumper cover, grille and hood-ledge finisher come off so you can reach the headlight bolts. Unplug the fog lights, front camera and sensors as equipped, remove the lamp, install the new one, refit the cover and aim the beams afterward.