Clear Black Sequential FULL LED Tail Lights Pair for Chevy Camaro (2016-2018)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Stock 6th-gen Camaro reds look soft next to clear/black sequential FULL LEDs—this pair snaps a sharp LED signature onto the 2016-2018 RS/SS rear. GENSSI's vehicle-specific set bolts in, plugs into the factory harness, and lets you switch sequential or static turns.
Important Fitment Note: Fits 2016-2018 Chevrolet Camaro RS and SS. FULL LED assemblies with sequential turn signals; the on/off switch toggles sequential versus static turn mode. Does not cover 2019+ facelift Camaro tails.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 2016-2018 | Chevrolet / Camaro RS/SS | Yes |
Specs
- Style: Black housing, clear lenses, sequential FULL LED
- Bulbs: Built-in LEDs only — sequential turn with on/off switch for static mode
- Sold as: Sequential FULL LED tail light pair
- Fit: Direct-fit FULL LED sequential tails for 2016-2018 Camaro RS/SS
What's included
- 1x Driver sequential FULL LED tail light
- 1x Passenger sequential FULL LED tail light
Installation — Chevrolet Camaro (2016-2018)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the trunk. Remove the rear side trim / access covers to reach the tail light fasteners and connectors.
- Disconnect each harness. Remove the mounting fasteners and carefully pull each factory tail straight back out of the quarter opening.
- Set the sequential on/off switch on each new lamp for sequential or static turn mode before final install.
- Seat the new clear/black FULL LED assemblies, reconnect plugs, and snug fasteners while checking quarter-panel and deck gaps.
- Refit the trunk trim, reconnect the battery, and test tail, brake, sequential/static turn, and reverse.
Buyer FAQ
Will these fit a 2019+ Camaro? No. This pair is for 2016-2018 Camaro RS/SS only—not the 2019+ facelift rear.
Can I run static turns instead of sequential? Yes. The included on/off switch toggles sequential turn mode to static.
Do I splice wiring? No. After trunk access, the FULL LED assemblies bolt in and plug into the factory harness.