Clear Lens Tail Lights Pair for Honda Accord Coupe (2006-2007)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
A red factory lens leaves a 2006-2007 Accord coupe looking plain across the trunk, and this clear pair opens that lamp while the factory LED brake panel still lights the brake. GENSSI's set is the left and right coupe housing, and the factory panel and sockets move over with no splicing.
Important Fitment Note: 2006-2007 coupe only. Move the factory LED brake panel into the new housing. A 2006-2007 sedan uses a different lamp. A 2003-2005 coupe uses the earlier bulb lamp.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 2006-2007 | Honda / Accord coupe | Yes |
| 2006-2007 | Honda / Accord sedan | No |
| 2003-2005 | Honda / Accord coupe | No |
Specs
- Style: Clear lens with a red housing outline. The factory LED brake panel moves into this housing
- Bulbs: Two amber 7440 turn bulbs are in the box. The LED brake panel, the reverse bulbs, and the sockets are not included
- Sold as: Pair — left and right clear coupe housings and two amber 7440 bulbs. The factory LED brake panel and the reverse sockets move over
- Fit: 2006-2007 Honda Accord coupe. The factory LED brake panel transfers. No splicing
Interchange
33551-SDN-A11, 33501-SDN-A11
What's included
- 1x Driver (left) clear tail light
- 1x Passenger (right) clear tail light
- 2x Amber 7440 bulbs
Installation — Honda Accord coupe (2006-2007)
- Confirm a 2006-2007 coupe. A sedan uses a different lamp. A 2003-2005 coupe uses the earlier bulb housing, not this LED-panel housing.
- Open the trunk and remove the trunk side trim. The rear bumper cover also comes off: the wheel-well screws, the lower pins, and the bolts that hold the cover. Use an 8mm socket, a 10mm socket, and a Phillips screwdriver.
- Unplug the tail-light connectors. Remove the mounting nuts and the bracket screws. Pull the lamp out. Do not hang it from the wires.
- Take the gasket off the old lamp. Remove the four screws on the LED cover, unplug the LED connector, and lift the factory LED brake panel out.
- Seat that LED panel in the new housing, plug it in, and reinstall the four screws and the gasket. Seat the included amber 7440 in the turn socket. Move the factory reverse socket. That socket is not in the box.
- Set the lamp in place. Install the nuts and snug them. Honda's spec on these nuts is 5 N·m, about 4 lb-ft. Reinstall the bumper cover.
- Check park, brake, both turn signals, and reverse, then repeat on the other side. Run water over the lamp to confirm the gasket seals.
Buyer FAQ
Is the LED brake panel in the box? No. Move the factory LED brake panel into this clear housing. The box has the left and right housings and two amber 7440 turn bulbs.
Does the sedan fit? No. This pair is the 2006-2007 coupe lamp. The sedan uses a different housing. A 2003-2005 coupe uses the earlier bulb lamp.
Which part numbers does this replace? Left replaces 33551-SDN-A11. Right replaces 33501-SDN-A11.