DRL LED Bar Low/Hi Beam Headlights for Lexus IS250 / IS350 / IS F (2006-2013)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Flat stock XE20 halogen lamps lose the face—V2 daytime DRL LED bars put a sharp Low/Hi LED signature on 2006-2013 IS250 / IS350 / IS F. GENSSI's Lexus IS pair is a vehicle-specific DRL LED bar set that bolts in and plugs into the factory harness.
Important Fitment Note: Fits 2006-2013 Lexus IS250 / IS350 / IS F factory Halogen headlight models only—not factory Xenon / HID equipped vehicles.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 2006-2013 | Lexus / IS250 / IS350 / IS F Halogen | Yes |
Specs
- Style: Black housing, clear lens, daytime-visible DRL LED bar with LED Low/Hi beams
- Bulbs: LED Low (H11) + LED High (9005); signal 7440 — LED Low/Hi / Incandescent signal
- Sold as: DRL LED bar Low/Hi headlight pair
- Fit: Direct-fit for 2006-2013 Lexus IS250 / IS350 / IS F factory Halogen models only
Interchange
81170-53270, 81170-53400, 81070-53240, 81070-53400, 81130-53270, 81130-53400, 81140-53240, LX2502132, LX2502133, LX2518125, LX2503132, LX2503133, LX2519125
What's included
- 1x Driver DRL LED bar Low/Hi headlight
- 1x Passenger DRL LED bar Low/Hi headlight
- LED Low Beam bulbs (H11)
- LED High Beam bulbs (9005)
Installation — Lexus IS250 / IS350 / IS F Halogen (2006-2013)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the hood. Remove the grille trim, upper bumper fasteners, and access covers needed to reach the headlight retaining bolts and clips.
- Support each headlight, remove the retaining bolts / clips, press the connector lock tabs, disconnect the harnesses, and pull the factory lamp straight forward off the locating pins.
- Install the included H11 Low and 9005 High LED bulbs into the new housings. Transfer any brackets or adjusters from the factory lamps only where the new assemblies clearly lack them.
- Align each new headlight on the locating pins, reconnect the harness plugs until the lock tabs click, snug the fasteners evenly while checking hood / fender / grille gaps, and leave trim loose until testing is done.
- Reconnect the battery, test DRL, low beam, high beam, parking, and signals, aim the beams on a level surface, then refit the grille and upper bumper trim.
Buyer FAQ
Will these fit factory Xenon / HID IS headlights? No. Fitment is factory Halogen XE20 models only—not factory Xenon / HID housings.
Are Low and High beams LED? Yes. Low (H11) and High (9005) are LED. Turn signals use 7440 sockets as equipped.
Do I splice wiring? No. After grille / upper bumper access, the assemblies bolt in and plug into the factory harness.