Halogen Headlights Pair for Jeep Wrangler JK and Wrangler Unlimited JK (2007-2018)

Give a JK Wrangler a clean factory look again. This original-style 7-inch halogen pair replaces tired or damaged round headlights on 2007-2017 Wrangler and Wrangler Unlimited, and on 2018 JK models. Each lamp is DOT and SAE compliant, and the H13 halogen bulbs come in the box so you can install a complete pair.

Fitment

Specs

• Sold as: driver and passenger pair
• Housing / style: original-style 7-inch round halogen housing, clear lens, black retaining ring
• Lighting: halogen, with H13 bulbs included
• DOT and SAE compliant
• New aftermarket assemblies, designed to replace the factory halogen units

Bulb size: H13 (included).

In the Box

• Driver-side headlight assembly
• Passenger-side headlight assembly
• H13 halogen bulbs

Interchange References

Replaces the original halogen housings used under 55078149AD (driver) and 55078148AD (passenger), including 55078149AA / 55078149AB / 55078149AC and 55078148AA / 55078148AB / 55078148AC, and Partslink CH2502175 / CH2503175.

Installation: Jeep Wrangler JK and Wrangler Unlimited JK (2007-2018)

On the JK Wrangler and Wrangler Unlimited, the headlights come out from the front of the grille. You do not need to remove the bumper. Professional installation and beam aiming are recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.

1. Open the hood. Pry out the six plastic clips along the top of the grille. Disconnect the turn-signal connectors at each end of the grille, then pull the grille forward off its lower clips and set it aside.
2. Remove the four T15 Torx screws that hold the headlight retaining ring. Pull the lamp forward, slide the red lock tab on the connector, press the release, and unplug the harness. Do not pull on the wiring.
3. Connect the factory-style connector to the new lamp and slide the red lock back into place. Seat the assembly in the opening, reinstall the retaining ring, and start the four T15 screws. Repeat on the other side.
4. Reinstall the grille and turn-signal connectors, reconnect the battery, and test low beam and high beam. Aim the lamps on a level surface before driving at night.

Frequently Asked Questions

Which vehicles do these headlights fit?
2007-2017 Jeep Wrangler and Wrangler Unlimited (JK), plus 2018 JK models. Compare your current lamps with our photos before ordering.

Will they fit a 2018-up Wrangler JL?
No. The JL uses a larger 9-inch headlight. This pair is the 7-inch JK lamp only, including 2018 JK models.

Do they fit Wrangler Unlimited?
Yes. JK Wrangler Unlimited uses the same 7-inch round headlights as the two-door JK Wrangler.

Are these a pair or a single lamp?
This is a complete driver and passenger pair, not a single-side lamp.

Do they include bulbs?
Yes. H13 halogen bulbs are included for both assemblies.

How are they installed on a JK Wrangler?
Open the hood, remove the six top grille clips, unplug the turn signals, and pull the grille off. Remove the four T15 screws in the retaining ring, unplug the connector (slide the red lock tab first), and swap the lamp. Reinstall the ring and grille, then aim the lamps before nighttime driving.