Red and Clear Halogen Tail Lights Pair for Chevy Suburban Tahoe / GMC Yukon Yukon XL (2000-2006)
$99.95
Ir directamente a la información del producto
Red and Clear Halogen Tail Lights Pair for Chevy Suburban Tahoe / GMC Yukon Yukon XL (2000-2006)
$99.95
DS-19168990
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Chevrolet Suburban 1500 and 2500, Tahoe, GMC Yukon, and Yukon XL 1500 and 2500 (2000-2006) only. They will not fit models with barn doors, 1995-1999 GMT400 SUVs, or 2007-up GMT900 SUVs. Compare your current housings with our photos before ordering.
Replace worn GMT800 SUV tails with this red and clear halogen pair. You get driver and passenger assemblies in a chrome housing, with a red tail and brake section and a clear reverse window. Reuse your existing halogen bulbs — bulbs are not included. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2000-2006 | Chevrolet Suburban 1500 | Red and clear halogen housing. Not barn-door models |
| 2000-2006 | Chevrolet Suburban 2500 | Same housing |
| 2000-2006 | Chevrolet Tahoe | Same housing |
| 2000-2006 | GMC Yukon | Same housing, including Denali trim |
| 2000-2006 | GMC Yukon XL 1500 | Not barn-door models |
| 2000-2006 | GMC Yukon XL 2500 | Not barn-door models |
Specs
- Sold as: a driver and passenger pair
- Style: chrome housing, red and clear lens
- Lighting: halogen tail, brake, turn, and reverse; bulbs not included
- DOT certified
- 12 V
- New aftermarket assemblies
- OEM cross-reference: 19168990, 19168991, GM2800170, GM2801170, GM2818199, GM2819199, 15832091, 15832092, 15224181, 15224182
What’s in the box
- Driver tail light assembly
- Passenger tail light assembly
Installation
- Open the liftgate or rear doors and peel back the cargo-area side trim to reach the nuts behind each lamp.
- Remove the nuts that hold the assembly to the quarter panel.
- Pull the housing straight back out of the opening, then unplug the factory connector and twist out the bulb sockets.
- Transfer the bulbs and sockets into the new housing, seat it on the factory studs, reconnect, and tighten the nuts.
- Repeat on the other side, then check tail, brake, turn, and reverse functions before putting the trim back.
A do-it-yourself installer can usually finish both sides in about 30-45 minutes with basic hand tools. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.