Red Halogen Tail Lights Pair for Chevy Impala (2006-2013) / Impala Limited (2014-2016)
$111.95
Ir directamente a la información del producto
Red Halogen Tail Lights Pair for Chevy Impala (2006-2013) / Impala Limited (2014-2016)
$111.95
DS-25971597
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Chevrolet Impala (2006-2013) and Impala Limited (2014-2016) only. They will not fit 2014-2016 Impala (the redesigned 10th-generation model) or 2000-2005 Impala. Compare your current housings with our photos before ordering.
Give a ninth-generation Impala a clean factory-style look with this red halogen tail light pair. You get driver and passenger quarter-panel assemblies in a chrome housing, with a red lens and a small clear reverse section at the inboard edge. Halogen bulbs are included. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2006-2013 | Chevrolet Impala | Ninth-generation body. Red halogen housing |
| 2014-2016 | Chevrolet Impala Limited | Carryover ninth-generation fleet model. Not the redesigned 2014-2016 Impala |
Specs
- Sold as: a driver and passenger pair
- Style: chrome housing, red lens
- Lighting: halogen tail, brake, turn, and reverse; bulbs included
- 12 V
- New aftermarket assemblies
- OEM cross-reference: 25971597, 25971598, GM2800193, GM2801193
What’s in the box
- Driver tail light assembly
- Passenger tail light assembly
- Halogen bulbs
Installation
- Open the trunk and peel back the trunk side trim to reach the nuts behind each quarter-panel lamp.
- Remove the nuts that hold the assembly to the quarter panel.
- Pull the housing straight back out of the opening, then unplug the factory connector.
- Seat the new housing on the factory studs, reconnect, and tighten the nuts.
- Repeat on the other side, then check tail, brake, turn, and reverse functions before putting the trim back.
A do-it-yourself installer can usually finish both sides in about 30-45 minutes with basic hand tools. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.