Red Halogen Tail Lights Pair for Ford F-150 F-250 F-350 Bronco (1980-1986) / F-100 (1980-1983)
$99.95
Ir directamente a la información del producto
Red Halogen Tail Lights Pair for Ford F-150 F-250 F-350 Bronco (1980-1986) / F-100 (1980-1983)
$99.95
DS-E4TZ13405B
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Ford F-150, F-250, F-350, and Bronco (1980-1986) and F-100 (1980-1983) only. They will not fit 1987-1991 or later F-series or Bronco. Compare your current housings with our photos before ordering.
Restore a 1980-1986 F-series or Bronco with this red halogen tail light pair. You get driver and passenger assemblies in a black housing, with a three-section red lens and a small reverse window. Reuse your existing halogen bulbs — bulbs are not included. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 1980-1986 | Ford F-150 | Red halogen three-section housing |
| 1980-1986 | Ford F-250 | Same housing |
| 1980-1986 | Ford F-350 | Same housing |
| 1980-1986 | Ford Bronco | Same housing |
| 1980-1983 | Ford F-100 | Same housing |
Specs
- Sold as: a driver and passenger pair
- Style: black housing, red and clear lens
- Lighting: halogen tail, brake, turn, and reverse; bulbs not included
- DOT certified
- 12 V
- New aftermarket assemblies
- OEM cross-reference: E4TZ13405B, E4TZ13404B, FO2800103, FO2801102
What’s in the box
- Driver tail light assembly
- Passenger tail light assembly
Installation
- Open the tailgate (or the Bronco liftgate) so you can reach the screws on the inner edge of each lamp.
- Remove the screws that hold the assembly to the bedside or quarter panel.
- Pull the housing straight back, then unplug the connector and twist out the bulb sockets.
- Transfer the bulbs and sockets into the new housing, seat it on the factory mounting points, reconnect, and tighten the screws.
- Repeat on the other side, then check tail, brake, turn, and reverse functions.
A do-it-yourself installer can usually finish both sides in about 20-30 minutes with a screwdriver. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.