Smoke FULL LED Halo Tail Lights 4pc for Chevy Corvette C4 (1991-1996)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Cloudy stock C4 reds dull a late-model Corvette rear—molded-smoke FULL LED halo lamps put a sharp blackout LED signature on the 1991-1996 face. GENSSI's 4pc Chevy Corvette C4 set is vehicle-specific outer and inner assemblies that bolt in and plug into the factory harness.
Important Fitment Note: Fits 1991-1996 Chevrolet Corvette C4 coupe and convertible. Full outer + inner 4pc smoke LED set—smoke is molded into the lens, not painted or stick-on tint. Does not fit 1984-1990 C4 tails.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 1991-1996 | Chevrolet / Corvette C4 | Yes |
Specs
- Style: Black housing, molded smoke lenses, FULL LED halo brake/signal
- Bulbs: FULL LED — built-in LEDs, no replaceable bulbs
- Sold as: 4pc smoke FULL LED halo tail set
- Fit: Direct-fit 4pc inner/outer FULL LED set for 1991-1996 C4
What's included
- 1x Driver outer smoke LED tail light
- 1x Passenger outer smoke LED tail light
- 1x Driver inner smoke LED tail light
- 1x Passenger inner smoke LED tail light
Installation — Chevrolet Corvette C4 (1991-1996)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the hatch / rear compartment. Access the inner and outer tail fasteners from behind the rear fascia / lamp pockets.
- Disconnect each harness. Remove the mounting fasteners and carefully pull the factory outer and inner lamps from the C4 openings.
- Compare old and new 4pc smoke LED assemblies side by side before install—confirm outer vs inner orientation.
- Seat the new smoke FULL LED halo set, reconnect plugs, and snug fasteners while checking fascia gaps on coupe or convertible.
- Reconnect the battery and test tail, brake, turn, and reverse on all four lamps.
Buyer FAQ
Will these fit an 84-90 C4? No. This 4pc smoke FULL LED set is for 1991-1996 C4 only.
Is the smoke just a tint film? No. The smoke is molded into the lens—not painted or stick-on overlays.
Do I splice wiring? No. After rear fascia / compartment access, the 4pc set bolts in and the built-in LEDs plug into the factory harness.