GENSSI hero — smoke sequential full LED tail lights Chevy Camaro (2016-2018) white background

Smoke Sequential Full LED Tail Lights Pair for Chevy Camaro (2016-2018)

$502.95
Ir directamente a la información del producto
GENSSI hero — smoke sequential full LED tail lights Chevy Camaro (2016-2018) white background

Smoke Sequential Full LED Tail Lights Pair for Chevy Camaro (2016-2018)

$502.95
DS-CAMARO-TAIL-SMOKE-SEQ-FULL-LED-2016-2018

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Stock 2016-2018 Camaro tails look flat from behind—these all-smoke full LED lamps give you a blacked-out look by day and a sequential LED signature at night. GENSSI's Camaro kit is a vehicle-specific complete tail light pair that bolts into the factory openings and connects to the factory harness.

Important Fitment Note: Fits 2016-2018 Camaro RS and SS. LT and LS models need an additional LED tail light harness to complete installation. The on/off switch on the lamp toggles the sequential turn signal to static.

Fitment

YEAR MAKE / MODEL FITS
2016-2018 Chevy / Camaro RS & SS Yes
2016-2018 Chevy / Camaro LT & LS With additional LED tail light harness

Specs

  • Style: Black housing, all-smoke lens (smoked at manufacture, not painted or tinted)
  • Bulbs: Built-in full LED with sequential turn signal — no bulbs required
  • Sold as: Smoke sequential full LED tail light pair
  • Fit: Direct-fit smoke full LED tails for 2016-2018 Chevy Camaro RS and SS

What's included

  • 1x Driver smoke sequential full LED tail light
  • 1x Passenger smoke sequential full LED tail light

Installation — Chevy Camaro (2016-2018)

  1. Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
  2. Open the trunk. Remove the four nuts holding the trunk trim around the latch, then remove the trim panel and set it aside.
  3. Release the interior trim clips with a Y-shaped trim tool, then remove the clips that hold the trim panel above each tail light and set that board aside.
  4. Remove the three 8 mm nuts holding each tail light, then pull the lamp straight out; if it resists, tap the retaining studs gently from inside the trunk. Pull the red lock tab on the harness connector, press the black center tab, and separate the connector by hand—do not pry it.
  5. Connect the new lamp to the factory harness, set the sequential / static switch where you want it, seat the studs in the body, and thread the three 8 mm nuts from inside the trunk.
  6. Test brake, parking, turn, and reverse before refitting the trim panels, clips, and trunk trim.

Buyer FAQ

Will the smoke lens fade? No. The smoke is part of the lens material from manufacturing, not paint or a tint film, so it will not peel or fade.

Do LT and LS Camaros fit? Yes, with an additional LED tail light harness to complete the connection. RS and SS models connect without it.

Can I turn the sequential signal off? Yes. A toggle switch on the back of the lamp changes the turn signal from sequential to static.

También te puede interesar