Black Housing HID Headlights Pair for Acura MDX (2007-2013)

A new left-and-right pair of factory-style HID headlight assemblies for the 2007-2013 Acura MDX with non-AFS HID headlights. Black housings, clear polycarbonate lenses and chrome reflector surfaces.

Fitment

Specs

• Condition: New
• Sold as: Driver-side and passenger-side pair
• Position: Front headlights
• Housing: Black; lens: Clear polycarbonate
• Low beam: D2S HID
• High beam: 9005 / HB3
• Bulbs and ballasts are not included.

In the Box

• 1 driver-side headlight assembly
• 1 passenger-side headlight assembly

Interchange References

33151-STX-A12; 33101-STX-A12; AC2518111; AC2519111.

Installation: 2007-2013 Acura MDX

This MDX requires front bumper-cover removal for headlight-assembly access. Professional installation is recommended, especially when transferring HID components.

1. Before disassembly, confirm the vehicle has non-AFS HID headlights and black ballasts. Compare the rear connections with the gallery; do not attempt to adapt silver ballasts.
2. With the lights off and the HID system safely isolated, remove the upper grille-cover clips and bumper/grille bolts. Release the lower bumper-to-splash-shield fasteners and the screws at each wheel-liner/bumper corner.
3. Release the bumper corners evenly from the fender retainers. Support the cover while disconnecting the fog-light wiring, then set the cover aside without pulling on the harnesses.
4. Remove the headlight mounting hardware, including the fasteners reached behind the bumper and at the support bracket. Disconnect the lamp wiring and lift out the assembly.
5. Transfer compatible bulbs and black ballasts as needed; these parts are not supplied. Compare the mounting points, sockets and seals before securing each replacement assembly.
6. Reconnect the wiring, test low beam, high beam, turn signals and side markers, then refit the bumper cover and splash-shield fasteners. Have the beam aim checked after installation.

Frequently Asked Questions

Will these fit an Acura MDX with adaptive headlights?
No. These assemblies are for 2007-2013 Acura MDX non-AFS HID models only.

Can I reuse my existing HID ballasts?
These housings work with the black ballast type only, not the silver type. Compare your existing ballasts with the compatibility image before ordering. Bulbs and ballasts are not included.

What bulb sizes do these headlights use?
D2S HID low beam and 9005 high beam. Bulbs are not included.

Does replacing the MDX headlight assembly require bumper removal?
Yes. On the 2007-2013 Acura MDX, the front bumper cover must be removed to access the headlight mounting hardware. Professional installation and beam aiming are recommended.