GENSSI hero — black sequential LED light bar tail lights Honda S2000 (2000-2009) white background

Black Sequential LED Light Bar Tail Lights for Honda S2000 (2000-2009)

$769.95
Passer aux informations sur le produit
GENSSI hero — black sequential LED light bar tail lights Honda S2000 (2000-2009) white background

Black Sequential LED Light Bar Tail Lights for Honda S2000 (2000-2009)

$769.95
DS-S2000-TAIL-BLK-SEQ-LED-BAR-2000-2009

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Stock S2000 tails look dated from behind—this black housing LED light bar set gives the AP1 and AP2 rear a sharp red bar signature and a sequential amber sweep. GENSSI's S2000 kit is a vehicle-specific complete tail light pair with AP1 / AP2 conversion hardware included and plug-and-play factory connection.

Important Fitment Note: Fits both the AP1 (2000-2003) and AP2 (2004-2009) S2000. The included AP1 / AP2 conversion hardware adapts the lamp to your chassis.

Fitment

YEAR MAKE / MODEL FITS
2000-2003 Honda / S2000 AP1 Yes
2004-2009 Honda / S2000 AP2 Yes

Specs

  • Style: Black housing, clear lens, full LED light bar with sequential amber turn signal
  • Bulbs: Built-in LEDs — red brake / parking light bar, amber sequential turn signal, white reverse. No bulbs required
  • Sold as: Black sequential LED light bar tail light pair
  • Fit: Direct-fit black LED light bar tails for 2000-2009 Honda S2000 AP1 and AP2

Interchange

33551-S2A-A02, 33551-S2A-A11

What's included

  • 1x Driver black sequential LED light bar tail light
  • 1x Passenger black sequential LED light bar tail light
  • x2 AP1 / AP2 conversion hardware sets (driver + passenger)

Installation — Honda S2000 AP1 / AP2 (2000-2009)

  1. Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
  2. Open the trunk and pull back the trunk trim panel behind each tail light (push-pin fasteners on the rear and side trim). Disconnect the connectors from the factory tail light.
  3. Remove the four 8 mm mounting nuts from each factory tail light and pull the lamp straight out of the body opening.
  4. Fit the included AP1 or AP2 conversion hardware to the new lamp for your chassis and connect the included wire adapters to the factory connectors. Check that the foam gasket is seated flat; replace it if it is distorted or stays compressed.
  5. Press the new lamp's studs through the body holes, thread the four 8 mm nuts from inside the trunk, and refit the trim.
  6. Reconnect the battery, test brake, parking, sequential turn, and reverse on both sides, then run water over the lamps to confirm there are no leaks.

Buyer FAQ

Will these fit both AP1 and AP2 S2000s? Yes. The kit includes separate AP1 and AP2 conversion hardware, so the same lamp covers 2000-2003 and 2004-2009 cars.

Is this a cover or a full tail light? A full replacement assembly. The red light bar, amber sequential turn signal, and white reverse are built-in LEDs inside a black housing with a clear lens—no overlay, no bulb swap.

How does the sequential signal look on the road? The amber turn signal sweeps across the lamp one segment at a time, so cars behind you read your turn direction instantly, even in daylight.

Vous aimerez peut-être aussi