Clear and Red Halogen Tail Lights Pair for Ford F-150 (2009-2014) / F-150 SVT Raptor (2010-2014)
$99.95
Passer aux informations sur le produit
Clear and Red Halogen Tail Lights Pair for Ford F-150 (2009-2014) / F-150 SVT Raptor (2010-2014)
$99.95
DS-BL3Z13405AA
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Ford F-150 (2009-2014) and F-150 SVT Raptor (2010-2014). They will not fit Flareside beds, 2004-2008 F-150 (including Heritage), Super Duty, or 2015-up F-150. This is a halogen pair, not a sequential LED set. Compare your current housings with our photos before ordering.
Refresh a 2009-2014 F-150 with this halogen tail light pair. You get driver and passenger assemblies with a clear and red lens in a black housing. Tail, brake, turn, and reverse functions use your existing halogen bulbs — bulbs are not included, so reuse the factory bulbs if they are still good. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2009-2014 | Ford F-150 | Styleside halogen housing. Not Flareside. Not Super Duty |
| 2010-2014 | Ford F-150 SVT Raptor | Same 2009-2014 styleside housing |
Specs
- Sold as: a driver and passenger pair
- Style: black housing, clear and red lens
- Lighting: halogen tail, brake, turn, and reverse; bulbs not included
- 12 V
- New aftermarket assemblies
In the Box
- Driver and passenger clear and red halogen tail lights
Interchange References
Replaces original-style 2009-2014 F-150 tail lights commonly crossed with BL3Z-13405-AA, BL3Z-13404-AA, FO2818148, FO2819148, FO2818150, and FO2819150.
Installation: Ford F-150 (2009-2014) and F-150 SVT Raptor (2010-2014)
On these trucks the tail lights bolt to the bedside and are reached with the tailgate open. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
- Open the tailgate. From the bed opening, locate the two bolts on the face of each tail light housing.
- Remove the bolts and pull the housing straight back out of the bedside. Do not pry on the lens.
- Unplug the factory connector.
- Plug the factory connector into the new housing until it clicks, set the housing into the opening, start the bolts by hand, then tighten them evenly.
- Repeat on the other side. Reconnect the battery and check tail, brake, turn, and reverse functions before you drive.