Red Halogen Tail Lights and Backup Lights Set for Chevy Corvette (1975-1979)

Red Halogen Tail Lights and Backup Lights Set for Chevy Corvette (1975-1979)

$99.95
Passer aux informations sur le produit
Red Halogen Tail Lights and Backup Lights Set for Chevy Corvette (1975-1979)
  • Red Halogen Tail Lights and Backup Lights Set for Chevy Corvette (1975-1979)
  • Four-piece 1975-1979 Chevy Corvette red tail and backup light set, front view
  • Close view of the red tail and clear backup lamps for a 1975-1979 Chevy Corvette
  • 1975-1979 Chevy Corvette tail and backup lamps with chrome housings
  • Back of a 1975-1979 Chevy Corvette tail lamp and chrome housing
  • Red tail lamp and clear backup lamp for a 1975-1979 Chevy Corvette
  • Two 1975-1979 Chevy Corvette red tail and backup lamps
  • Front and back of a 1975-1979 Chevy Corvette tail and backup lamp
Red Halogen Tail Lights and Backup Lights Set for Chevy Corvette (1975-1979)

Red Halogen Tail Lights and Backup Lights Set for Chevy Corvette (1975-1979)

$99.95
DS-5965543-SET

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Fitment warning: This set fits Chevrolet Corvette (1975-1979) only. It will not fit earlier or later C3 years that use a different tail or backup lamp. Compare your current lamps with our photos before ordering.

Replace the 1975-1979 Corvette rear lamps with this four-piece halogen set. You get two red tail lamps and two clear backup lamps, which is the complete rear-lamp set for these years. The lamps use the factory mounting points. Bulbs are not included — reuse your factory bulbs or install new ones of the original type.

Installation for 1975-1979 Chevrolet Corvette

  1. Open the rear compartment and locate the fasteners that hold each round tail lamp and each backup lamp to the rear panel.
  2. Remove the fasteners and pull the lamp out far enough to reach the bulb socket. Twist the socket out of the housing.
  3. Transfer the factory bulb to the new lamp, or install a new bulb of the original type.
  4. Seat the new lamp in the opening, start the fasteners by hand, and tighten them evenly so the bezel sits flush.
  5. Repeat for the remaining three lamps, then check tail, brake, turn, and reverse functions.

A do-it-yourself installer can usually finish both sides in about 30-45 minutes with basic hand tools. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.

Vous aimerez peut-être aussi