Smoked Sequential LED Tail Lights Pair for Jeep Grand Cherokee (2005-2007)

Smoked Sequential LED Tail Lights Pair for Jeep Grand Cherokee (2005-2007)

$309.95
Passer aux informations sur le produit
Smoked Sequential LED Tail Lights Pair for Jeep Grand Cherokee (2005-2007)

Smoked Sequential LED Tail Lights Pair for Jeep Grand Cherokee (2005-2007)

$309.95
DS-PT0350A-S

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Upgrade your 2005-2007 Jeep Grand Cherokee with this black-housing, smoked-lens LED tail light pair. A light-guide running lamp with start-up animation, bright LED brake section, dynamic sequential turn signal and LED reverse light replace the factory lamps and bolt into the original mounting points.

Fitment

Years Make / Model Generation
2005-2007 Jeep / Grand Cherokee 3rd gen (WK)

2005-2007 Jeep Grand Cherokee (WK). Listing title says 2005-2007; check your factory lamp shape on 2008-2010.

Features

  • Light-guide LED running light with start-up animation
  • LED brake light
  • Dynamic sequential LED turn signal
  • LED reverse light
  • Black ABS housing, smoked polycarbonate lens
  • IP67 sealed, DOT / SAE compliant (per supplier)

Signs you need new tail lights

  • Cracked, faded or hazy lens
  • Water or condensation inside
  • Dead LED sections or broken sockets

What's included

  • 1 x driver side (left) tail light
  • 1 x passenger side (right) tail light
  • Connection harness
  • All LEDs built in. No extra bulbs needed

Installation: 2005-2007 Jeep Grand Cherokee (3rd gen (WK))

Tools: 10 mm socket, Phillips screwdriver, plastic trim tool. About 15-20 minutes per side.

  1. Open the liftgate. Each tail light is held by two screws on its inner edge, visible in the liftgate opening.
  2. Remove the two screws, then pull the lamp straight back to release its outer clips from the body.
  3. Unplug the factory connector and set the old lamp aside.
  4. Connect the new lamp (supplied harness where included), routing the wire so it is not pinched.
  5. Align the lamp on its clips, press it home and refit the fasteners.
  6. Test running, brake, turn and reverse on both sides.
  7. If the turn signal flashes fast, add a load resistor or LED flasher.

FAQ

What does this fit?

2005-2007 Jeep Grand Cherokee (WK). Listing title says 2005-2007; check your factory lamp shape on 2008-2010.

Are bulbs included?

Yes. The lamps are fully LED with every light source built in, so no extra bulbs are needed.

Does it have a sequential turn signal?

Yes. The turn section lights in a dynamic sequential sweep, and the running light plays a start-up animation.

Is this sold as a pair?

Yes: driver side (left) and passenger side (right).

How long does installation take?

About 15-20 minutes per side with basic hand tools.

Vous aimerez peut-être aussi