Smoked Sequential LED Tail Lights Pair for VW Jetta Sedan (2015-2018)
$354.95
Passer aux informations sur le produit
Smoked Sequential LED Tail Lights Pair for VW Jetta Sedan (2015-2018)
$354.95
DS-PT0216A-S
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Upgrade your 2015-2018 VW Jetta Sedan with this black-housing, smoked-lens LED tail light pair. A light-guide running lamp with start-up animation, bright LED brake section, dynamic sequential turn signal and LED reverse light replace the factory lamps and bolt into the original mounting points.
Fitment
| Years | Make / Model | Generation |
|---|---|---|
| 2015-2018 | Volkswagen / Jetta | MK6 facelift sedan |
2015-2018 Volkswagen Jetta sedan (MK6 facelift, incl. GLI). Not 2011-2014 or 2019+ Jetta.
Features
- Light-guide LED running light with start-up animation
- LED brake light
- Dynamic sequential LED turn signal
- LED reverse light
- Black ABS housing, smoked polycarbonate lens
- IP67 sealed, DOT / SAE compliant (per supplier)
Signs you need new tail lights
- Cracked, faded or hazy lens
- Water or condensation inside
- Dead LED sections or broken sockets
What's included
- 1 x driver side (left) tail light set (outer + inner)
- 1 x passenger side (right) tail light set (outer + inner)
- Connection harness
- All LEDs built in. No extra bulbs needed
Installation: 2015-2018 VW Jetta Sedan (MK6 facelift sedan)
Tools: 10 mm socket, Phillips screwdriver, plastic trim tool. About 30-40 minutes per side.
- Open the trunk. Peel back or remove the side trim liner behind the outer (body-side) lamp.
- Unplug the outer lamp connector and remove its retaining nuts, then pull the lamp straight back.
- Remove the trunk-lid inner trim panel (plastic trim tool) to reach the inner lamp.
- Unplug the inner lamp and remove its retaining nuts, then lift it out.
- Fit the new outer and inner sections, refit the nuts and connect the new lamps (route wiring so the hinge cannot pinch it).
- Refit the trim and test running, brake, sequential turn and reverse on both sides.
- If the turn signal flashes fast, add a load resistor or LED flasher.
FAQ
What does this fit?
2015-2018 Volkswagen Jetta sedan (MK6 facelift, incl. GLI). Not 2011-2014 or 2019+ Jetta.
Are bulbs included?
Yes. The lamps are fully LED with every light source built in, so no extra bulbs are needed.
Does it have a sequential turn signal?
Yes. The turn section lights in a dynamic sequential sweep, and the running light plays a start-up animation.
Is this sold as a pair?
Yes: driver side (left) and passenger side (right) outer and inner sections.
How long does installation take?
About 30-40 minutes per side with basic hand tools.